Air Conditioner Condenser Unit

Note air-conditioning maintenance - air conditioner outdoor unit, negative ion air conditioning - home appliance industry

< BR> check the cleaning every two weeks once the indoor unit Dust network, use less than 40 , hot water, otherwise it will create Dust network deformation.
Indoor Hanging Machine Dust net periodic cleaning and maintenance steps:
1. Cut off the power, open the inlet gate, the right to use the machine into the air from the inlet gate gate roof support;
2. Gently push Dust Network Center protruding upward, and then to the drop-down, remove the Dust Network;
3. The air filter mesh embedded in Dust around the box;
4. Installation of air condition with dust filters;
5. Put down the wind gate into the roof, close the inlet gate.
Indoor rackmount machine Dust net periodic cleaning and maintenance steps:
1. Hand always has the wind gate into the indoor unit, after the top side and gently pull out after the hard and then pull out and lift;
2. Clean indoor Dust network;
3. After the Dust Network moisture to dry air into the indoor unit into the grid, the further into the indoor unit can be.
Outdoor cleaning and maintenance requirements:
1. Air conditioning Outdoor unit's heat exchanger, such as foreign body or surface dust too, should be promptly cleaned with a brush, to ensure the air conditioning compressor is not damaged.
2. Seasonal use, should fully inspect the power supply is powered on, the outdoor unit where dust cover should be removed.
3. A long time without air conditioning, power should be broken, the outdoor unit stamped dust cover.
Air conditioning maintenance and answers to frequently asked questions
(On)
Air conditioning smell
Summer air-conditioning refrigeration, in the just-machine odor may blow. This is because when using the cooling function, prone evaporator condensate, adhesion of dust in the air, resulting in mold, blow out the smell. Should be noted that before each shutdown is set to air conditioning mode (or higher temperature setting), to air conditioning to work 3 to 5 minutes, condensate evaporator surface drying on it. If the filter frequency for the less usual or smoke more when the room with dust filters will increase the odor, clean the filter as long as the time (usually once every two weeks cleaning) or in indoor spraying a breath of fresh air inlet Department agent, you can reduce this phenomenon.
air conditioning when there is condensation outlet
Air conditioning refrigeration, the indoor air outlet formation of condensation phenomena for the following reasons: low temperature setting; ambient air humidity; wind speed set at low speed; the louvers to adjust the angle properly, a long time down blowing or downward swings, the louvers of the temperature difference between inside and outside.
The event of the above phenomenon, should be adjusted to set the temperature, so temperature below 5 . If the indoor humidity, the dehumidifier should be air-conditioning set, such as do not have this feature, you need to keep the ventilation, while wind speed is set to medium and high wind speed, can reduce the condensation phenomenon.
Air Conditioner with spots
Anion air-conditioning used for some time, the surface and inside the machine within a machine near the wall are often dark spots appear, this is due to anion adsorption in the environment with dust, bacteria function, smoke, bacteria attached to the network and Dust wall, a small case attached to the surface for a long time will have visible mold, but this is not a failure, but not moldy.

---

I am an expert from cnc-machiningparts.com, while we provides the quality product, such as Precision Fasteners , China Sheet Metal cabinet, machining parts supplier,and more.

Article Source: ArticlesBase.com